Tag - Twitch

Entries feed - Comments feed

Thursday, April 8 2021

Artsy Fartsy Night, We are even MORE INSANE!!!

Did some work on the 3D Printers, yup they are being right pains in the asre! Nikki painted her corner shelf, came up with a new design few her coasters. We went through some of our "tried and true" products on Etsy. Not a terribly exciting night, but we were there!!! -- Watch on Twitch at  […]

Continue reading

Thursday, April 1 2021

"Artsy Fartsy" - We are INSANE!!!

Did some serious screwing around with the 3D Printers, some success, some failure. Still getting the workflow down. Nikki created a bookend on the GlowForge and some coasters. She even used the table saw!!!! Watch on Twitch - https://www.twitch.tv/videos/971933230 Or from YouTube  

Thursday, March 25 2021

"Artsy Fartsy" - What can we whip up tonight?

Not a super exciting stream, we're still getting back into the swing of things, we'll get there soon, we PROMISE! Nikki slung some more paint and stain, we fired off a GlowForge project or two. Then Ender was cruising away doing a pegboard paint bottle holder. I set up an M1A1 print project to  […]

Continue reading

Saturday, March 13 2021

"Friday Night Lights" - Better Late Than Never!!!

Quickie update since we didn't do a full stream at 7pm. Have a few products going on the Printers, a Star Trek Voyager in the Prusa, another Trinket Box run in the Ender and another Moon Phase Clock in the GlowForge. Watch on Twitch too! - http://designcreations.design/  […]

Continue reading

Wednesday, February 24 2021

"Artsy Fartsy" Stream. Taking on the paints of the world!

Unfortunately last night's Pirate Chest Trinket Box didn't yield the highest quality print so we started another job with higher settings. Tested some colors on the "Ooopsy" one. Nikki is still working on her Star Trek Voyager so we saw some more paint go down on that. Worked on some stain  […]

Continue reading

Movers, Shakers and Makers! Marathon Stream!

Whew! A 4 hour and 45 minute stream!! We are beat! Made an incense burner for Essence of Magic to fulfill an order that came in today, whooohoo! Then we moved on to creating a new Pirate Chest Trinket Box in 3DS Max, slicing it and sending it to the Prusa! Hopefully just over 7 hours from now we  […]

Continue reading

Wednesday, February 17 2021

Back in the swing of things!

We are firing up the Twitch stream again and starting to stream on a schedule. Yes we promise, we will stick to it this time!! This session is about our experience with 3D Printers and 3D Printing from a newcomer's perspective. 3D Printers and 3D Printing from a newcomer's perspective. What I have  […]

Continue reading