Tag - Nikki

Entries feed - Comments feed

Sunday, December 5 2021

P90: Nearing the finish line!

Getting closer to the end with the P90. I have 2 coats of black, unfortunately we grabbed gloss at the store so I'm going to have to hit it with a matte sealer too. There still will be a bit of a shine but not too terribly bad. Of course Nikki claimed it for herself. I made her an SG-1 Logo plaque  […]

Continue reading

Tuesday, November 23 2021

More Elegooooooo

I have to say the second run at multi-colors came out MUCH better!! It is an articulated butterfly keychain for Nikki's Mom.  

Sunday, October 24 2021

Baby Glock - G26

Finally got it all printed save a couple of internal parts for the slide. I ended up reprinting the Frame and Slide. I was just not happy with the initial quality and the way the trades engraved. So I went into 3DS Max and added the trades. I TRIED to get a much higher resolution where the trades  […]

Continue reading

Saturday, September 18 2021

Fini!

Nikki FINALLY finished her Sherman Calliope.     Came out Pretty Darn good!!! Now get to work on the Nebelwerfer!!!! LOVE YA BABY!!!  

Sunday, September 5 2021

Off my chest!

I posted this to Facebook on Sept 5th, 2021. It took A LOT to post and admit. I am copying it here in case Facebook decides the post doesn't meet their "community standards" and deletes it on me. ************************************************************************** I was sitting on  […]

Continue reading

Thursday, April 1 2021

"Artsy Fartsy" - We are INSANE!!!

Did some serious screwing around with the 3D Printers, some success, some failure. Still getting the workflow down. Nikki created a bookend on the GlowForge and some coasters. She even used the table saw!!!! Watch on Twitch - https://www.twitch.tv/videos/971933230 Or from YouTube  

Saturday, March 27 2021

"Friday Night Lights" - Rinse, Repeat, Same Ol' Same Ol'

A SEVEN AND A HALF HOUR MARATHON!!! Yup, we done broke our record!!! Did quite a few GlowForge projects, a few 3D Prints, some 3D design (made a keyboard support for the craft table). Went through the leveling process on the Ender 3v2 with the BL-Touch and Smith3D firmware. (right around the 3 hour  […]

Continue reading

Sunday, December 9 2018

My Baby!

Nikki_2000-03.png

My Baby when she was 21. Ain't she cuuuuute! .

Saturday, September 1 2018

Working Hard or Hardly Working

Nikki_Workstation.jpg

We picked up Nikki's monitors and our chairs from my folks in Georgia last week. Her dual monitor stand came in today. We mounted her monitors and got her workstation setup. Here she is hard at "work". She even made a nice little hanging spot for her VR setup. She's so spoiled!   […]

Continue reading