Tag - GlowForge

Entries feed - Comments feed

Thursday, April 1 2021

"Artsy Fartsy" - We are INSANE!!!

Did some serious screwing around with the 3D Printers, some success, some failure. Still getting the workflow down. Nikki created a bookend on the GlowForge and some coasters. She even used the table saw!!!! Watch on Twitch - https://www.twitch.tv/videos/971933230 Or from YouTube  

Saturday, March 27 2021

"Friday Night Lights" - Rinse, Repeat, Same Ol' Same Ol'

A SEVEN AND A HALF HOUR MARATHON!!! Yup, we done broke our record!!! Did quite a few GlowForge projects, a few 3D Prints, some 3D design (made a keyboard support for the craft table). Went through the leveling process on the Ender 3v2 with the BL-Touch and Smith3D firmware. (right around the 3 hour  […]

Continue reading

Thursday, March 25 2021

"Artsy Fartsy" - What can we whip up tonight?

Not a super exciting stream, we're still getting back into the swing of things, we'll get there soon, we PROMISE! Nikki slung some more paint and stain, we fired off a GlowForge project or two. Then Ender was cruising away doing a pegboard paint bottle holder. I set up an M1A1 print project to  […]

Continue reading

Saturday, March 13 2021

"Saturday Night Live!" - A weee impromptu stream.

A look at some of the completed prints and some of the To Do prints. Watch on Twitch - http://designcreations.design/     BE AWARE- I did do some ranting about programmers and laziness and the sad state of affairs in the software development process lately. I know NOT ALL programmers are lazy and  […]

Continue reading

Wednesday, February 24 2021

"Artsy Fartsy" Stream. Taking on the paints of the world!

Unfortunately last night's Pirate Chest Trinket Box didn't yield the highest quality print so we started another job with higher settings. Tested some colors on the "Ooopsy" one. Nikki is still working on her Star Trek Voyager so we saw some more paint go down on that. Worked on some stain  […]

Continue reading