Tag - Airsoft

Entries feed - Comments feed

Sunday, December 5 2021

Officially Finished!

Nikki's P90 build is officially finished!!!   I even whipped up the little plaque on the Elegoo Neptune 2D in black and silver dual extruded. THAT machine is a lot of fun! Now of course since she claimed that one for herself, I get to make a Triple Rail version for myself. But I plan on doing a few  […]

Continue reading

P90: Nearing the finish line!

Getting closer to the end with the P90. I have 2 coats of black, unfortunately we grabbed gloss at the store so I'm going to have to hit it with a matte sealer too. There still will be a bit of a shine but not too terribly bad. Of course Nikki claimed it for herself. I made her an SG-1 Logo plaque  […]

Continue reading

Friday, December 3 2021

P90 Going Strong

We're nearing the finish line! Just have to finish printing the sights then decide if we are going to print a magazine or get an airsoft one with the translucent body and dummy rounds.   Of course, why do a P90 if you aren't going to do a Five-seveN to compliment it.  

Thursday, November 4 2021

Getting CLOSER!!!!!

We are starting to see the light at the end of the tunnel and I don't think it's a train!! Finishing printing some internals for the trigger assembly, a few body pins, firing pin, bolt and the magazine and we will be ready to paint. So what do ya think, should I pop an M203 on this bad girl? Go all  […]

Continue reading

Tuesday, November 2 2021

Work on the Bushmaster ACR continues!

WoooHooo, we've got the shakings of a barrel!!!!     

Thursday, October 28 2021

Baby Glock be Done!

Painted and mounted. Just gotta let the last coat of matte clear coat dry and she's all ready! This was a tricky one. A lot of the components were modeled so there were a BUNCH of little pieces. I had to redesign the slide spring and follower though. The original was just too flimsy and weak. It  […]

Continue reading

Bushmaster ACR aka Magpul "Masada"

Cruising right along with the ACR. The silver PLA kinda gives it that Machined Aluminum look.  

Sunday, October 24 2021

Baby Glock - G26

Finally got it all printed save a couple of internal parts for the slide. I ended up reprinting the Frame and Slide. I was just not happy with the initial quality and the way the trades engraved. So I went into 3DS Max and added the trades. I TRIED to get a much higher resolution where the trades  […]

Continue reading

Saturday, October 9 2021

Is that a Glock in your pocket or are you just glad to see me?

Finally finished the Glock 17. I used files from TWO different Glock prints from Thingiverse. This one took quite a bit of fiddling around to get things to mesh together correctly. Hopefully the last mag printing now will fit right and activate the slide and barrel correctly.